The ONE-x-Six has all of the telephone interface and control equipment needed for talk show programming. A single rack mounting unit houses both a Telos ONE digital hybrid and a six-line, broadcast phone system. For system control, the ONE-x-Six uses either our desktop Switch Console or Assistant Producer software (both sold separately).
To meet the needs of smaller facilities, we have made the ONE-x-Six very easy to install. Phone lines are connected using standard RJ-11C modular plugs. All Switch Console features found in our larger systems are fully implemented. A standard telephone set may be used for call screening.
The ONE-x-Six provides clean, quiet, and reliable switching of multiple telephone lines. Phone lines may be directly connected without intervening phone equipment. With the ONE-x-Six, successful talk shows sound great, are easy to produce, and won't cost a fortune in hardware. The basic ONE-x-Six may be expanded with the addition of a second Switch Console or a second hybrid for improved conferencing.
- 2U rack space unit
- Eight module slots for customizability
- Terrific audio with a wide frequency response and low noise and distortion
- Dual mute bus for multiple levels of paging priority
- Individual channel and master volume controls
- Master volume can be controlled via an external potentiometer
- Balanced, transformer-isolated screw terminal output with switchable impedance
- Auxiliary output for connecting additional mixer or recording device
- Bridge in/out jack for system expansion
- Bass and treble controls
- Status LEDs for power, peak, protect, normal, and signal
- Protection circuitry for overheat and overload
|Processor||True digital. Second generation Texas Instruments TMS320C25 processor. 8kHz sampling rate. Internal digital input and output gain processing, filtering.|
|Trans-Hybrid Loss||>40dB with pink noise or voice as test input, all dynamic enhancement processing switched off. With the override and output expander functions switched in, trans-hybrid loss is enhanced to >50dB. Send Level to Phone Line -10dBm average level. Maintained by internal digital AGC.|
|Send Audio Input||XLR female connector. Active balanced. Accommodates -24dBm to +12dBm levels in LINE mode; -68dBm to -35dBm in MIC mode. Front panel screwdriver level adjustment.|
|Caller Audio Output||XLR male connector. Active differential. Output levels to +14dBm depending on caller telephone line level and adjustment of front panel screwdriver level adjustment. Drives 600Ω .|
|Aux/Mix Output||XLR male connector. Active differential. In AUX mode, this output is an isolated second output. In MIX mode, this is a combined send and caller output. Input to Mix output: Unity gain. <0.04 % THD; +12dBm clip point.|
|Phone System Section|
|Processor||80188 processor running software written in the “C” language.|
|Music On Hold Input||XLR female connector. Active balanced. 10kΩ input impedance. -20 to +4dBu level. An AGC circuit maintains consistent levels to held callers for any input level within this range.|
|Communication Between Switch Console and Rack Mount Unit||9600 Baud RS-232 using six-conductor modular cable. Switch Console can be located up to 100' from the rack mount unit; 250' with the Local Power Supply installed. |
|RS-232 Port||1200 Baud using “AT” style DB-9 connector. Simple ASCII commands are used for communication in both directions.|
|Frequency Response (caller to output)||200 – 3400Hz, ±1dB.|
|Noise and Distortion (caller to output)||Distortion: Typical 0.4% THD+N, measured @ 1kHz at any level from -48dBm to -8dBm. Signal-to-Noise: >72dB referenced to 0dBm phone level.|
|Included Accessories||Manual with pull-out user instructions, 25' six-conductor modular cable for connection of Switch Console, and power cord.|
|Rack Mount Unit Power Supply||Universal, input switching operable from 85VAC to 250VAC, 50Hz or 60Hz. Power consumption 30 watts. Incorporates surge suppression and line voltage “dip” protection.|
|Rack Mount Unit Physical Dimensions||Standard rack mount, one rack unit high. 93/8" deep (23.8cm)|
|Switch Console Physical Dimensions||33/16" x 123/4" x 41/4" 8.1cm x 7.0cm x 10.8cm|
|Weight (rack mount unit and Switch Console packaged in single carton)||6 pounds (15 pounds shipping weight) 2.7 kilograms (6.8 kilograms shipping weight)|Digital Hybrid Section
Identical to the all-digital performance and features of the Telos ONE.
Phone System Section with Switch Console
- Six-line call selector with enhanced functionality makes talk show management easy and intuitive
- Program-on-hold input routes your selected audio to listeners waiting for air.
- Caller screening and conferencing features make ONE-x-Six perfect for either on-air or recording environments.
- Full implementation of Switch Console special functions.
Dale Pro Audio guarantees that our prices will be competitive and that shopping with us will always be a great value.
If you've found a deal that looks better than ours, we want to hear from you!
Product Rating: (0.00) # of Ratings: 0 Click Here to rate this product|
There are no comments for this product. CLICK HERE to be the first one to share your opinion!